This little keychain is a soft, stuffed capital letter Y in pale butter yellow, decorated with a cluster of lilac flowers and fresh green leaves. A gold split ring and short chain hang from the top of one arm, and a tiny puffy lilac heart dangles beside it on its own chain.
The colors are soft and springlike: pale yellow for the letter, lilac for the two flowers, the bud and the heart, sage green for the leaves, and a dot of yellow in each flower center. The style is classic amigurumi. You work tight single crochet in a spiral so no stuffing shows through.
All instructions use US crochet terms. The finished letter is about 4.25 in (10.8 cm) tall, 2.75 in (7.0 cm) wide across the arm tips, and 0.75 in (1.9 cm) thick, not counting the hardware.
Construction is simple. You crochet two arms as small closed tubes, join them in one round, and keep going down the stem, stuffing as you go. The flowers, bud, leaves and heart are tiny separate pieces that you sew on or attach at the end.
Finished Size and Construction
- Finished letter size: 4.25 in (10.8 cm) tall x 2.75 in (7.0 cm) wide x 0.75 in (1.9 cm) thick
- Skill level: Easy to intermediate (small spiral rounds, joining two tubes)
- Terminology: US crochet terms
- Yarn weight: DK (light #3) cotton or cotton blend
- Hook: 2.5 mm (US B/1 or C/2)
- Number of pieces: 1 finished keychain made of 1 stuffed letter body (2 arms joined into 1 stem) plus small appliqués: 2 flowers, 1 bud, 4 leaves and 1 heart charm
- Layout: The flowers, bud and leaves run down the left side of the letter, from the left arm to the lower stem
- Piece size: Each arm is about 1 in (2.5 cm) wide; the stem is about 1.25 in (3.2 cm) wide
- Size before border: Same as finished size
- Border depth: None; the letter has no added border
Materials
Choose a smooth, tightly plied DK cotton. Cotton shows each stitch clearly and holds the letter shape well. Avoid fuzzy or very splitty yarn, because tiny appliqués need clean edges. The amounts below assume a yarn of about 125 m (137 yd) per 50 g.
- Pale yellow (letter body, flower centers): 10 g, about 25 m (27 yd)
- Lilac (flowers, bud, heart): 4 g, about 10 m (11 yd)
- Sage green (leaves): 2 g, about 5 m (5 yd)
All quantities include a small safety margin.
Tools and notions:
- 2.5 mm crochet hook
- Polyester fiberfill, about 5 g
- 1 gold split keyring, about 1 in (2.5 cm), with a short attached chain
- 1 extra short gold chain, about 1 in (2.5 cm), for the heart
- 2 gold jump rings, 6 mm
- 2 pairs of flat-nose pliers
- Locking stitch marker
- Tapestry needle and sewing pins
- Scissors
Abbreviations (US Terms)
- ch – chain
- sl st – slip stitch
- sc – single crochet
- hdc – half double crochet
- dc – double crochet
- tr – treble crochet
- inc – 2 sc in the same stitch
- sc2tog – single crochet 2 together. Use the invisible decrease: insert the hook in the front loops only of the next 2 sts, yarn over, pull through both front loops, yarn over, pull through 2.
- MR – magic ring
- st(s) – stitch(es)
- ( ) – stitch count at the end of the round
Special stitch – 4-dc cluster: (Yarn over, insert hook in ring, pull up a loop, yarn over, pull through 2 loops) 4 times, yarn over, pull through all 5 loops on hook.
Gauge and Checkpoints
Gauge: 11 sc and 12 rounds = 2 in (5.1 cm) in a tight spiral, before stuffing. That is 5.5 sts and 6 rounds per inch.
Make one arm first to test your gauge. It is a complete piece on its own and takes only a few minutes.
Checkpoints:
- After arm Round 11: The arm is about 1.8 in (4.6 cm) long and, pressed flat, about 1.1 in (2.8 cm) wide.
- After stem Round 26: The stem measures about 2.5 in (6.4 cm) from the crotch of the Y.
- Finished letter: About 4.25 in (10.8 cm) tall and 2.75 in (7.0 cm) wide across the arm tips.
If your arm is longer than 2 in (5.1 cm), or the fabric looks loose with gaps, go down to a 2.25 mm hook. If the arm is shorter than 1.6 in (4.1 cm) and stiff to work, go up to a 2.75 mm hook. Stitch counts stay the same either way; only the size changes.

Letter Body
Work in continuous spiral rounds. Do not join or turn. Move the stitch marker up to the first stitch of each new round.
Arm (make 2)
With pale yellow:
Round 1: 6 sc in MR. (6)
Round 2: Inc in each st around. (12)
Rounds 3–11: Sc in each st around. (12)
That is 9 plain rounds, which give the arm its straight sides. Rounds 1 and 2 form the softly rounded tip.
For the first arm, sl st in the next st, fasten off and leave a 6 in (15.2 cm) tail. For the second arm, do not fasten off; keep the loop on your hook.
Stuff both arms lightly. Then press each one gently so it becomes a slightly flattened oval rather than a round tube. The arms should feel springy, not hard.
Joining Round
Hold the two arms side by side, tips pointing up and away from each other. The working yarn of the second arm should sit on the inner side, where the arms touch.
Round 12 (join): Insert the hook into the next st of the first arm and sc; this st joins the two arms. Sc in the next 11 sts around the first arm. Sc in the next st of the second arm and in the next 11 sts around it. (24)
Place your marker in the first st. You now have one 24-st tube: 12 sts from each arm, worked 1 per existing stitch, with no extra stitches added at the seam. A small gap remains at the crotch. You will close it later with the first arm’s tail.
Stem
Round 13: (Sc 4, sc2tog) 4 times. (20)
Round 14: (Sc 3, sc2tog) 4 times. (16)
These two decrease rounds narrow the join into the stem, so the Y has a smooth, slightly flared neck.
Rounds 15–26: Sc in each st around. (16)
That is 12 plain rounds. Stuff the join and upper stem after Round 18, then add stuffing every few rounds so it stays even. Press the stem lightly flat as you go, to match the arms.
Checkpoint: After Round 26, the stem is about 2.5 in (6.4 cm) long from the crotch.
Round 27: (Sc 2, sc2tog) 4 times. (12)
Top up the stuffing now, pushing it firmly into the bottom of the stem.
Round 28: Sc2tog 6 times. (6)
Fasten off with a 6 in (15.2 cm) tail. Thread it through the front loops of the last 6 sts, pull tight to close, and weave in.
Close the Crotch Gap
Thread the first arm’s tail onto the tapestry needle. Use small whipstitches to close the gap between the arms on the inside of the Y. If the area feels hollow, push in a pinch of stuffing first. Weave in the end.
Flower (make 2)
Round 1: With pale yellow, 5 sc in MR, pull the ring closed, sl st in the first sc to join. (5) Fasten off.
Round 2: Join lilac in any st. *(Sl st, ch 2, 3 dc, ch 2, sl st) all in the same st; repeat from * in each of the remaining 4 sts. (5 petals)
Fasten off with an 8 in (20.3 cm) tail for sewing. Each flower measures about 1 in (2.5 cm) across. Weave the yellow tail into the back.
Bud (make 1)
With lilac, make a MR. Ch 2, work a 4-dc cluster into the ring, ch 2, sl st into the ring. Pull the ring tight so the cluster curls into a small round bud about 0.4 in (1.0 cm) across. Fasten off with a 6 in (15.2 cm) tail.
Leaf (make 4)
With sage green, ch 7.
Side 1: Starting in the 2nd ch from the hook: sl st, sc, hdc, dc, hdc, sc. (6)
Tip: Ch 1, then turn the piece to work along the opposite side of the foundation chain.
Side 2: Sc, hdc, dc, hdc, sc, sl st. (6)
Sl st into the tip and fasten off with a 6 in (15.2 cm) tail. Each leaf is about 0.9 in (2.3 cm) long, pointed at both ends and widest in the middle.
Heart Charm (make 2 layers)
With lilac, make a MR. Into the ring work: ch 3, 3 tr, 3 dc, ch 1, tr, ch 1, 3 dc, 3 tr, ch 3, sl st into the ring. Pull the ring tight. (13 sts, not counting chains)
The single tr in the middle forms the point. The ch-3 at each end forms a top lobe. Each layer is about 0.75 in (1.9 cm) wide.
Make a second layer the same way. Hold both layers together with wrong sides facing in, and whipstitch around the edge with lilac. Add a tiny pinch of fiberfill before closing for a puffy finish. Weave in the ends.
Assembly
- Arrange the appliqués. Lay the letter flat with the arms up. Pin the bud on the left arm, about 0.5 in (1.3 cm) below its tip. Pin one flower just below the bud, where the left arm meets the stem. Pin the second flower lower on the stem, slightly toward the right edge and about 0.75 in (1.9 cm) above the bottom.
- Add the leaves. Tuck one leaf beside the bud, one to the left of the upper flower, one below it on the left edge and one beside the lower flower.
- Sew them down. Using each piece’s tail, sew around its outer edge with small stitches through the top layer of the letter only. Stitch around each flower center to give it a slight dome. Leaves need only a line of stitches down the center plus a tack at the tip.
- Attach the hardware. Open a jump ring with two pairs of pliers. Pass it through 2 sts of Round 2 at the tip of the right arm, add the end link of the keyring chain, and close it fully. Open the second jump ring and pass it through the top dip of the heart. Add the extra chain, close the ring, and hook the free end of that chain onto the split ring.
Border
This keychain has no added border. The arms, stem and appliqués are finished at their natural edges, so border gauge and border depth are both zero.
The math still closes neatly because every piece ends on an exact count. Each arm tip starts with 6 sts. The joining round uses all 12 + 12 = 24 arm stitches with nothing added. The stem then steps down 24, 20, 16, 12, 6, so the bottom closes as neatly as the arm tips. Each flower petal uses exactly 1 st of the 5-st center.
Final Blocking
- Lightly mist the letter with water, or hold a steam iron 1–2 in (2.5–5.1 cm) above it. Never press the iron onto the stuffing.
- Shape the arms by hand so they angle out evenly, about 2.75 in (7.0 cm) apart at the outer tips.
- Flatten the front slightly with your palm so the appliqués lie on a smooth surface.
- If the flower petals or leaf tips curl, pin them flat.
- Let everything dry completely before using the keychain.
Final Quality-Control Checklist
- The letter measures about 4.25 in (10.8 cm) tall and 2.75 in (7.0 cm) wide.
- Both arms have 11 rounds and are the same length.
- No stuffing shows between stitches.
- The crotch gap is fully closed.
- The bottom of the stem is rounded and closed with no hole.
- Each flower has 5 even petals and a yellow center.
- The leaves are sewn flat, with tips pointing outward.
- The jump rings are fully closed with no gap.
- The heart charm hangs freely beside the letter.
- All ends are woven in and trimmed.
Troubleshooting
Stuffing shows through. Your tension is loose. Go down a hook size or use a tighter cotton.
The arms are different lengths. Recount the rounds; one arm probably has 10 or 12. Remake it with 11.
There is a hole at the crotch. Add more whipstitches, working through both arms and the first stitch of the join.
The stem twists to one side. This is normal for spiral rounds. Hold the letter flat and steam it, or sew the appliqués on the side that naturally faces forward.
The petals look uneven. Make sure each petal goes into its own center stitch, and pull the center ring fully closed.
The leaves curl. Steam them flat before sewing, and sew down the center line.
A jump ring slips out. Pass it through 2 stitches instead of 1, and close the ends so they meet flush.
Care
Spot clean with a damp cloth and mild soap, then air dry flat. Avoid soaking, which can tarnish the gold hardware and shift the stuffing.

Final Notes
The measurements are easy to check at each stage. A gauge of 11 sc and 12 rounds per 2 in (5.1 cm) gives a 12-st arm about 1.8 in (4.6 cm) long. The two arms join into a 24-st tube, which narrows to a 16-st stem about 2.5 in (6.4 cm) long by Round 26. The stem then closes down to 6 sts, giving a letter about 4.25 in (10.8 cm) tall and 2.75 in (7.0 cm) wide. Two flowers, a bud, four leaves and a puffy heart finish the design.
Once you know the method, the same arm-and-stem idea works for other letters too.
Happy crocheting!