The Sweetheart Ladder Curtain is made of four tall filet crochet strips in turquoise teal and soft peach. Each strip has a column of solid hearts, and every heart is outlined by a thin ring of open mesh. Open ladder edges run down both sides of each strip, so light comes through at the seams as well as around the hearts.
The colors alternate teal, peach, teal, peach. It has a cheerful cottage look that suits a sunny window or a doorway, or it can be a room divider.
This pattern uses US crochet terms. The finished curtain measures 46 in (116.8 cm) wide and 75.4 in (191.5 cm) long, not counting the tabs. The hanging tabs add about 2.5 in (6.4 cm) above the rod.
You crochet four identical strips from the bottom up in filet blocks and spaces. Then you whip-stitch the strips together along their long edges. Last, you add a two-row single crochet border along the top and bottom edges, and work eight hanging tabs from the top border.
Finished Size and Construction
- Finished size: 46 in (116.8 cm) wide × 75.4 in (191.5 cm) long, plus tabs
- Skill level: Intermediate (filet reading, color sections)
- Terminology: US
- Yarn weight: Worsted (#4) cotton
- Hook: 5.0 mm (H-8)
- Number of pieces: 4 strips + 8 tabs
- Layout: 4 strips side by side, 1 row high
- Piece size: 11.5 in (29.2 cm) × 74.4 in (189.0 cm), 46 stitches × 124 rows
- Size before border: 46 in (116.8 cm) × 74.4 in (189.0 cm)
- Border depth: 0.5 in (1.3 cm) at the top and at the bottom; the long side edges have no border
Materials
Use a smooth worsted-weight cotton or cotton blend. Cotton shows the filet hearts clearly and hangs straight without stretching too much. Avoid fuzzy yarn, because it fills in the mesh.
- Teal: about 600 g / 1,200 yd (1,097 m)
- Peach: about 600 g / 1,200 yd (1,097 m)
These amounts assume about 200 yd (183 m) per 100 g and include roughly a 10% margin.
Tools:
– 5.0 mm (H-8) crochet hook
– Tapestry needle
– 4 small yarn bobbins (for the color sections in the border)
– Stitch markers
– Rust-proof pins and a blocking surface
– Measuring tape
– Curtain rod up to 1.25 in (3.2 cm) in diameter
Abbreviations (US Terms)
- ch – chain
- sc – single crochet
- dc – double crochet
- sk – skip
- sp – space
- st(s) – stitch(es)
- RS / WS – right side / wrong side
Filet squares:
– B (block): 3 dc wide. Over a block, dc in each of the next 3 dc. Over a space, work 2 dc in the ch-2 sp, then dc in the next dc.
– S (space): Ch 2, sk 2 sts (or the ch-2 sp), dc in the next dc.
– Edge S at the start of a row: Ch 5 (counts as dc + ch 2), turn, sk the first dc and the next 2 sts, dc in the next dc.
– Edge S at the end of a row: Ch 2, sk 2, dc in the top of the turning chain.
Every row has 15 squares, which is 46 sts (3 × 15 + 1). The turning chain always counts as a stitch.
Gauge and Checkpoints
Gauge: 16 dc = 4 in (10.2 cm), and 5 dc rows = 3 in (7.6 cm). One filet square measures 0.75 in (1.9 cm) wide × 0.6 in (1.5 cm) tall.
Test with one full strip before you start the other three. Use these checkpoints:
- After Row 2: The strip is 46 sts and 11.5 in (29.2 cm) wide.
- After Row 14 (first heart done): The strip is 8.4 in (21.3 cm) tall.
- Each 12-row heart repeat: Adds 7.2 in (18.3 cm).
- Finished strip: 124 rows, 74.4 in (189.0 cm) long.
If 16 dc measure more than 4.25 in (10.8 cm), go down half a hook size. If they measure less than 3.75 in (9.5 cm), go up half a size. If your width is right but the rows are too tall, pull up less yarn on each dc. All four strips must be within 0.5 in (1.3 cm) of each other in length.

Strip Pattern (Make 4)
Ch 48.
Row 1 (RS): Dc in 4th ch from hook (the skipped ch count as 1 dc) and in each ch across. (46 sts)
This solid row closes off the bottom of the ladders.
Row 2: Edge S, 13 B, edge S. (46 sts: 1 S, 13 B, 1 S)
Heart Repeat (Rows 3–122)
Read each row as 15 squares from right to left. Because filet is symmetrical, you can follow the same order on WS rows. Each row has 46 sts.
- Repeat row 1: S, 13 B, S
- Repeat row 2: S, 6 B, S, 6 B, S (the space under the heart’s point)
- Repeat row 3: S, 5 B, S, B, S, 5 B, S (the point of the heart)
- Repeat row 4: S, 4 B, S, 3 B, S, 4 B, S
- Repeat row 5: S, 3 B, S, 5 B, S, 3 B, S
- Repeat row 6: S, 2 B, S, 7 B, S, 2 B, S (widest part of the heart)
- Repeat row 7: S, 2 B, S, 7 B, S, 2 B, S
- Repeat row 8: S, 2 B, S, 3 B, S, 3 B, S, 2 B, S (the dip between the lobes)
- Repeat row 9: S, 3 B, S, B, S, B, S, B, S, 3 B, S (the tops of the lobes)
- Repeat row 10: S, 4 B, S, 3 B, S, 4 B, S (outline above the lobes)
- Repeat rows 11–12: S, 13 B, S
Work repeat rows 1–12 a total of 10 times (Rows 3–122).
Square 1 and square 15 are always spaces, which makes the open ladder. Squares 2 and 14 are always blocks, which makes the solid column inside it. The heart is 7 squares wide, which is 5.25 in (13.3 cm). Its outline ring takes up repeat rows 2–10, which is 5.4 in (13.7 cm) tall.
Row 123: Edge S, 13 B, edge S. (46 sts)
Row 124: Ch 3 (counts as dc), dc in each st across. Work 2 dc in each ch-2 sp. (46 sts: 44 dc + 2 dc worked in the 2 edge spaces)
Fasten off and weave in the ends. The strip measures 11.5 in (29.2 cm) × 74.4 in (189.0 cm).
Make All Pieces
- Teal: 2 strips
- Peach: 2 strips
Layout, viewed from the RS with Row 1 at the bottom:
| Teal | Peach | Teal | Peach |
A B C D
Before joining, lay all four strips flat and check that the hearts line up across the strips. Row 2 of every strip should sit at the same height.
Joining
Method: Whip stitch with the RS facing up.
- Place strip A next to strip B with Row 1 of both at the bottom.
- Thread a tapestry needle with peach yarn.
- The edge of each row is either a turning-chain stitch or an end dc. Each row has one of these edge posts on each strip.
- Work 2 whip stitches per row through both edge posts, matching row to row. This gives 248 stitches per seam (124 rows × 2).
- Join B to C with teal yarn, and C to D with peach yarn.
Tension: Keep the whip stitches snug but flat. If you pull too tight, the seam puckers and the ladders close up. The ladders should stay open next to the seam.
Checkpoint: Two joined strips measure 23.0 in (58.4 cm) wide, and three measure 34.5 in (87.6 cm). The full joined panel measures 46 in (116.8 cm) × 74.4 in (189.0 cm).
Border
Border gauge: 16 sc = 4 in (10.2 cm), and 2 sc rows = 0.5 in (1.3 cm).
The border is worked across the top and bottom edges only. Each strip’s section of the border is worked in that strip’s own color.
Starting count: 4 strips × 46 sts = 184 sc. There are no extra stitches at the seams.
Bottom Border
Wind 1 bobbin of each color for each section. With the RS facing, work into the foundation chain.
Row 1: Sc in each foundation ch: 46 teal, 46 peach, 46 teal, 46 peach. (184 sc)
To change color, work the last sc of a section until 2 loops are left on the hook. Finish it with the next color, and drop the old color to the WS.
Row 2: Ch 1, turn, sc in each sc, changing colors at the same points. (184 sc)
Fasten off.
Top Border
Row 1: With the RS facing, sc in each st of Row 124, color-matched as before. (184 sc)
Row 2: Ch 1, turn, sc in each sc. (184 sc)
Fasten off.
Tabs (Make 8)
In each 46-st section of the top border, place markers on sts 6–11 and on sts 36–41. That gives 5 + 6 + 24 + 6 + 5 = 46.
Tab Row 1: With the RS facing and the matching color, join the yarn in the first marked st. Sc in the 6 marked sts. (6 sc)
Tab Rows 2–20: Ch 1, turn, sc in each sc. (6 sc)
The tab is 1.5 in (3.8 cm) wide × 5 in (12.7 cm) long. Fold it to the WS and sew Row 20 to the back of the top border at the tab’s base. This makes a 2.5 in (6.4 cm) loop.
Why the math works: The border has the same 184-st count as the four Row 124s combined. At 16 sc per 4 in, 184 sc measure exactly 46 in (116.8 cm), the same as the joined width. The edges stay flat with no ruffling or cupping. The tabs sit evenly over a 46-st span, so the weight of each strip is spread across its width.
Final Blocking
- Soak the curtain in cool water for 15 minutes.
- Press out the water. Don’t wring it. Roll it in towels.
- Lay it flat on a large surface or a clean floor covered with towels.
- Pin the width to 46 in (116.8 cm), with each strip at 11.5 in (29.2 cm).
- Pin the length to 75.4 in (191.5 cm).
- Open each mesh square in the ladders and heart outlines with your fingertips.
- Straighten the seams and line up the hearts across the strips.
- Let it dry completely. Then hang it for 24 hours to settle the drape.
Final Quality-Control Checklist
- Every strip has 46 sts and 124 rows
- All 10 hearts point down and line up across the strips
- The ladder edges on both sides of every strip are open and even
- The seams are flat and both ladders stay visible at each seam
- The top and bottom borders have 184 sc each, with colors matching the strips
- The 8 tabs are 6 sc wide, evenly placed, and securely sewn
- The panel is 46 in (116.8 cm) × 75.4 in (191.5 cm)
- All ends are woven in on the WS
Troubleshooting
The hearts look blurry.
A block over a space needs exactly 2 dc in the ch-2 sp. Check that you aren’t working into the chains themselves.
The strip gets wider as you go.
You are adding a stitch at the edge. Count to 46 at the end of each row, and make sure the turning chain counts as a stitch.
The ladders twist.
Work the edge-space ch-5 firmly, and anchor the end-of-row dc in the turning chain every time.
The strips are different lengths.
Block them to match. If the difference is more than 0.5 in (1.3 cm), check your tension and redo the last repeat.
The border flares.
Your sc are too loose for the 184-st count. Go down a hook size for the border only.
The tabs are tight on the rod.
Add 2 to 4 rows to each tab.
Care
Hand wash or machine wash on a gentle cycle in cool water, inside a mesh bag. Dry flat, then rehang while slightly damp so the curtain hangs straight.

Final Notes
Here is how the measurements build up:
- 16 dc = 4 in (10.2 cm) and 5 rows = 3 in (7.6 cm)
- One 46-st strip = 11.5 in (29.2 cm) wide
- 124 rows = 74.4 in (189.0 cm)
- Four strips = 46 in (116.8 cm)
- 184 border sc keep that width
- Two border rows at each end bring the length to 75.4 in (191.5 cm)
- The tabs add 2.5 in (6.4 cm) above the rod
If the first strip passes every checkpoint, the rest of the curtain will come together without problems. Happy crocheting!